Corgi Vanguard Ford Cortina Mk3 2.0 GXL Daytona Yellow VA10320 1:43 scale

In the late 1960s, Ford set about developing a third generation Cortina, which would be produced in higher volumes than before. 

The MacPherson strut front suspension was replaced with more conventional double A-arm suspension to give the car a soft 'freeway' ride. The larger engines induced distinct understeer.

Ford UK originally wanted to call it something other than Cortina, but the name stuck. Although the Mark III looked significantly larger than the boxier Mark II, it was actually the same overall length, but 4 inches (100 mm) wider.

Trim levels were now Base, L (for Luxury), XL (Xtra Luxury), GT (Grand Touring) and GXL (Grand Xtra Luxury). 1.3 L, 1.6 L and 2.0 L engines were offered, the 1.6 L having two distinct types - the Kent unit for models up to GT trim and a SOHC Pinto unit for the GT and GXL, the latter of which was also offered in 1600 form for a short while. 2.0 L variants used a larger version of the 1600 Pinto unit and were available in all trim levels except base.

Four headlights and Rostyle wheels marked out the GT and GXL versions, while the GXL also had bodyside rubstrips, a vinyl roof and a brushed metal and black tail panel on the GXL and plain black one on the GT. All models featured a downward sloping dashboard with deeply recessed dials and all coil suspension all round. In general styling and technical make up, many observed that the Mark III aped the Vauxhall Victor FD of 1967.